Secret Builders Society
03 / Build & Learn

How to Build Your First Gundam Model Kit

From opening the box to a clean, finished kit on your shelf — a calm, step-by-step first build.

Beginner · 9 min read

Before you start

A first build is about learning the process, not perfection. Choose a kit you are excited about — an Entry Grade or High Grade is ideal (see Gunpla Grades Explained) — and set up a clear, well-lit table. You will want nippers, a hobby knife and a cutting mat at minimum; the tools guide explains each.

Plan for more than one session. Stopping between body sections keeps the build relaxed.

1. Read the manual

Open the instruction manual before cutting anything. Gunpla manuals are mostly pictures, so learn the symbols on the first pages: they show actions such as cutting, which side faces out, parts to keep as spares and where stickers go. Each step shows the parts you need using a code like A1-12, meaning runner A1, part 12.

Every kit is different. If anything in this guide disagrees with your kit’s own manual, follow the manual.

2. Find parts on the runners

Parts come attached to plastic frames called runners. Each runner has a letter (and sometimes a number) moulded onto a tag, and each part has a small number next to it. Lay the runners out and match their letters against the parts list at the start of the manual.

  • Only cut parts for the step you are on — loose parts are easy to mix up or lose.
  • Mirrored left and right parts often look alike; check the number twice.

3. Clip parts cleanly

Use the two-step cut: cut a little away from the part first, then trim the remaining stub close to the surface with a second cut. Cutting directly against the part in one go can leave white stress marks or a dent.

4. Clean up nubs

A small bump, or nub, usually remains where the part was attached. Shave it level with light strokes of a hobby knife, always cutting away from yourself, then smooth it with sanding sticks if you want a cleaner finish. Many builders tidy only the nubs that will be visible.

5. Assemble step by step

  • Follow the manual’s order. Later steps often depend on earlier parts being in place.
  • Test-fit before pressing hard. Line up pegs with holes and press evenly. If a part will not close, check its orientation rather than forcing it.
  • Watch the small details. Some steps ask you to insert a part before closing two halves, or to fit a joint in a specific direction.
  • Separating parts: if you need to undo a mistake, gently lever along the seam with a dedicated part separator or a flat plastic tool rather than a knife.

Most kits build in sections — head, torso, arms, legs, then weapons and accessories — before bringing everything together.

6. Stickers and decals

Many kits include stickers (sometimes called seals) for small colour details or eyes. Lift them with tweezers, line them up and press down from the centre outward. Water-slide decals, where included, need water and more patience; follow the kit’s instructions.

7. Simple finishing

You do not need paint for a great-looking first kit. Two easy upgrades:

  • Panel lining with a fine marker makes engraved detail stand out (see the tools guide).
  • A topcoat — usually a matte spray — evens out sanding marks and hides sticker edges. Spray in a well-ventilated area, follow the can’s safety directions and apply light coats.

Common first-build problems

  • White marks on plastic: usually from cutting too close in one go — use the two-step cut next time. Light sanding and a topcoat can reduce them.
  • A loose joint: check the part is fully seated and facing the right way.
  • A missing part: check the runner again and the floor around your desk. If it is truly missing or broken, the kit’s manufacturer may offer a parts service — see the manual.

Finished? Browse the Gundam kits listed in our catalogue for your next build, or contact the shop with questions.